Zenki S14 Sr20det Power FC D-Jetro Question

[wafflez66]

Okay, so I am installing my power fc d-jetro (maf to map), and I installed the IAT into the intake manifold, but am unclear where to wire it in on the harness. the manual says which pins to use but it's all in japanese so I don't know which wire goes to which pin. there is a brown wire and a red wire... any help would be much appreciated. thanks in advance.

Jon

[s15specR]

I have that in english at home, it's 26 and 2? can't remember off top, will find out and get back to you.

[wafflez66]

thank you sooooo much! that's awesome. please let me know.

[jspaeth]

wait a sec....i believe i wrote a post about this somewhere:


here's the thread:

http://zilvia.net/f/tech-talk/170290-powerfc-d-jetro-setup-pictures.html


To clarify, which motor do you have?

Is your motor a redtop, an S13 blacktop, or an S14 blacktop (you have VVC then).

What type of ECU do you have:

E5
E6
WC
61
62
63
J4

I am PRETTY SURE that the directions I gave should be okay for any of those ECUs, but in my case, it was a J4 ECU (for a S13 blacktop out of a 97-98 Type X 180sx)

[wafflez66]

the ecu was a wc for a zenki s14 sr20det engine. I can see what they want me to tap into but I just don't know which wire is which wire. I don't have to put a connector into my ecu as it has a wire already in both locations. so if I just see which one is a ground I should/could just put the brown wire on that one and assume the red wire goes to the other? thanks.

Jon