ok i did it... but....

[240racer1]

Ok so i wne to the "junkyard" today, and I found a 93 cluster , but the instrument harness had been cut instead of nicely pulled. So i looked around some more, found a 91 with the cluster still in. SO I pulled it, brought it home, and everything lights up, and the temp/feul work, but the tach and the speedo are dead.... could this be from the harness being different? if i find another (93 vs. the 91) harness will that work, or should i try and switch for the 93 cluster, and keep looking for the 93 instrument wiring harness?

just trrying to trouble shoot...

thanks for the help, people!!

Steve

[240racer]

what year is your car again?

[240racer1]

1993 se coupe

[240racer]

everything should work, maybe there is a problem with the console you got. The wiring isn't different. Maybe there is a AT, MT thing going on, did all these cars have the same transmission. I don't know how they do the speed signal on the AT, but I assume it's a little different. I'm running a '91 tach (from a analog cluster) in a '89 digitial console with the stock wiring harness and have no problems. Everybody with the '89 or '90 has been able to do that, so it's not a big deal. Check connections, I'll send you a PM too.

[S13Grl]

Make sure you plugged them in where they're supposed to be. IIRC, they're the same size connectors, and look the same too.

[drift freaq]

the only difference between the auto speed sensors and the manual speed sensors on 89-93 is at the trans itself and the actual speed sensor itself. The wiring is the same at the guage cluster i.e. there is no cluster differences.