z32 maf wiring, concerns

[devonkyle77]

ok so i am installing a z32 maf and i am concerned with the splicing of the pigtail to the engine harness wires. as i understand it, it is very important that the maf wires be "shielded" the plug/pigtail that came with my greddy intake doesnt appear to have shielded wires. the wires from my engine harness were extended long enough by phase 2 when they did my harness that they will reach to the plug no problem.

so should i use as little of the wire on the plug as possible? what are your suggestions?
thanks in advance!

[projectRDM]

The shield isn't too important, at least not so much that your concerns are warranted. As long as it's shielded up to say 18" from the plug you're fine.

[Bigsyke]

IMO I think the shielded part not touching the actual wire is more important