PDA

View Full Version : Oh no, no bolts on my exhaust manifold


MyFirst240SX
12-27-2002, 11:22 PM
I have had a wierd ticking noise in my engine bay i traced to my exhaust manifold and today i took the sheild off of the manifold and only one side of the manifold has bolts! the to wouldn't take a new bolt and the stud that should be at the bottom isn't there.

does this mean i have to tap/die my engine :/? is this happen much?
sean

West
12-28-2002, 12:07 AM
No you can fix it real ezily with the bolts from Nissan that you can get for about $4 a piece. Use lots of wd-40 and get new gaskets and it should be fixed in about 30 min. I didnt have to tap/die my bolts because they were just missing off my 89 SOHC Jalopy, although one of the bolts I couldnt get it, it didnt leak anymore because of the new gasket. If they are broken then get a drill set with a screw extractor, Sears sells them.

MyFirst240SX
12-28-2002, 12:56 AM
thanks mark

onboost
12-31-2002, 05:43 AM
might want to put a new exhaust gasket too.
the existing gasket might have being blown since it did not have strong even clamping force across the flange. Also the flange might be warped a bit from the hot exhaust gas escaping to only one side.
New gasket is probably recommanded

MyFirst240SX
12-31-2002, 01:31 PM
i just bought two gaskets, 2 studs, two bolts, two washers so i should have fun tomorow
sean

onboost
12-31-2002, 07:20 PM
good luck!