clutch pedal pressure

[turbosx]

i looked around and i can find anything regrading the same problem,
OK, i change the clutch, master and slave and i don't have any pressure on the pedal i bled the line and there is no leaks has anyone else had this problem

thanks in advance

[ms!3]

you still using the stock dampener?

[dino6192]

when you press in on the clutch have someone check if your slave moves at all? that way you at least know its a hydro issue. if not then it possible the clip on your TO bearing isnt on correctly, which may be causing the fork to have a entirely different angle. happened to me once.

[turbosx]

when you press in on the clutch have someone check if your slave moves at all? that way you at least know its a hydro issue. if not then it possible the clip on your TO bearing isnt on correctly, which may be causing the fork to have a entirely different angle. happened to me once.

the slave moves and it picks up pressure and then it loses it, this all happend befor i change everything i went to bleed the line on the slave and it just sucked the fluid and the pedal went down i dont know if it still has air i allready used 2 cans of brake fluid

[turbosx]

thanks for the help i figured it out

[Rayne]

What was the problem?