PDA

View Full Version : tps question


kazuma
07-25-2008, 09:21 AM
Okay so I stopped the stupid oil leak I had, the car would run but I wasnt able to time it at all, and now it wont start :mad: !!!

I have checked my timing and had a nissan tech check it as well and he says I am either bang on or just a bit off but it shouldnt not run at all, it should run but shitty. I know the timing is okay, the only thing that I was wondering about is the TPS.

My TPS reading as it shows on the safc is .235, I think this is too low, am I right? should it be between .45 and .5 at close? When I put it wide open throttle it goes to over 4v which also think is correct as that is what most people are getting on here.

I hope the problem is this dumb tps :D its really a pain when everything is done but you cant get the car running.

Sileighty_85
07-25-2008, 09:31 AM
SR?

If So check the wiring.
Look at the wire bundle around the #4 injector area, make sure no wires are being rubbed through.

kazuma
07-25-2008, 09:35 AM
SR?

If So check the wiring.
Look at the wire bundle around the #4 injector area, make sure no wires are being rubbed through.

oops forgot to mention this is a k24de :D

DALAZ_68
07-25-2008, 10:12 AM
oops forgot to mention this is a k24de :D
OBDI or OBDII :ughd:

kazuma
07-25-2008, 12:27 PM
OBDI or OBDII :ughd:

OBD I.

message is too short :D

Oo_Skyline_oO
07-25-2008, 12:33 PM
what oil leak did you fix??? you probably forgot to plug something back in, check mafs, ignition coil/resistor, make sure your spark plug cables are in correcf order, bad tps will make it run shitty, but it won't make it NOT start at all, I've had this problem with plenty motors.