what do you guys think of this

[moses]

this is my first thread im posting where i dont have a problem. i decided to make a tube to make colder air to hit my intake. i was board and wanted to do a project. i got the idea because someone else had a shop do it for them on another car.it took about $20 for the rivit gun, $28 for the aluminum and i already had the dremel. with a lot of little cuts and trial and error i finally did it. this is the outcome

this is where it is coming into:http://i340.photobucket.com/albums/o334/driftn240sx/carvent.jpg

here it is looking in from the light hole: http://i340.photobucket.com/albums/o334/driftn240sx/light.jpg

here it is through the vent: http://i340.photobucket.com/albums/o334/driftn240sx/pipe.jpg

and this is where it comes out: http://i340.photobucket.com/albums/o334/driftn240sx/hole.jpg

this is my first custom project. tell me what you guys think and what i could do to make it better. its not air tight but it should be good enough, right?
i didnt feel much of a difference when i was driving but im sure it does a little something right?
sorry if the pics dont work ill try again.

[racepar1]

Pics don't work!

[moses]

thanks how about now

[berz]

its gonna work but u wont feel any change , you did what u had to do now clean up that flash u left from cutting that hole and call it a day champ!!