JFoxx
07-15-2008, 06:08 PM
i just replaced my clutch to a stage 4 this one wouldnt be able to handle expected power i will be making. it has about 1200 miles on the clutch and i bought my new clutch as a kit so dont need flywheel either. would perfer pick up but i might consider shipping at buyers expense..(im in national city/ downtown san diego)
JUN Auto lightweight flywheels are one piece and made of Chromoly. These JUN AUTO Chromoly lightweight flywheels are 200% stronger than stock steel flywheels. (14lbs)
exedy stage 2 clutch, 3puck design, 400hp- 350ft-lbs torque rating.
Clamp Load (lbs): 1760. Disc Outer Diameter: 240
*do not have alignment tool, do have bearing that i was using...recommend getting new ones.*
exedy clutch-pressure plate $250 obo
jun flywheel-$300 firm
i also have stock cams, valve springs and rear seats all in good condition(will post pics if interested)..
how do i put multiple pics up?
JUN Auto lightweight flywheels are one piece and made of Chromoly. These JUN AUTO Chromoly lightweight flywheels are 200% stronger than stock steel flywheels. (14lbs)
exedy stage 2 clutch, 3puck design, 400hp- 350ft-lbs torque rating.
Clamp Load (lbs): 1760. Disc Outer Diameter: 240
*do not have alignment tool, do have bearing that i was using...recommend getting new ones.*
exedy clutch-pressure plate $250 obo
jun flywheel-$300 firm
i also have stock cams, valve springs and rear seats all in good condition(will post pics if interested)..
how do i put multiple pics up?