View Full Version : z32 brake upgrade assistance
asobanai
06-24-2008, 01:04 AM
s14 - i have managed to install the calipers and rotors sucessfully, however i noticed that the brake balance was much more in the front than the rear. i would brake and my rear end locks right up. i just put the bnr33 vlsd and it was a little much, i would imagine if i did the rears as well it will equalize the brake balance. Your opinion or knowledge? im thinking of getting some drilled and slotted rotors temporarily until i can get the rear brakes/calipers/spindles in the future. then again there is the brake booster and master cylinder from the z32 as a brake performance factor. aluminum 30mm they are, any words advice are appreciated.
Modrified
06-24-2008, 01:49 AM
did you install your calipers in a way so the brake bleeder nipples are on the top of the caliper?
an_orange_s2k
06-24-2008, 01:52 AM
you should upgrade the brake master cylinder to the z32. brake booster is up to you
GSXRJJordan
06-24-2008, 02:10 AM
So you're running Z32 front brakes and stock rear brakes, with a Z32 M/C? Or are you running the stock S14 M/C?
Z32 fronts, stock rears = Z31 M/C for correct balance/feel. I run this setup.
Z32 fronts/rears = Z32 M/C.
infinitexsound
06-24-2008, 06:28 AM
So you're running Z32 front brakes and stock rear brakes, with a Z32 M/C? Or are you running the stock S14 M/C?
Z32 fronts, stock rears = Z31 M/C for correct balance/feel. I run this setup.
Z32 fronts/rears = Z32 M/C.
i run the same.... full z32 with z31 mc..... feels good....
pbcstylez
06-24-2008, 02:06 PM
yah im runnin the s14 auto/abs bmc, BM-44? i think, and it feels almost stock
vBulletin® v3.8.11, Copyright ©2000-2021, vBulletin Solutions Inc.