Ninjabread
06-15-2008, 12:04 PM
I have an s13 sr in my car, but the powersteering pump I have seems to be off an s14 sr (bolts up to the block just fine, but it uses a 3 rib belt instead of a 4 rib).
My quesion is this : do the pulleys align? The first belt I bought was a 4 rib so I trimmed it down after the guy at Canadian Tire (napa) said it would work fine. (ya, don't try that, it doesn't work). I drive to the track ( about 2 hours) and not but 4-5 runs in the belt explodes.
So I'm not sure if it was the fact that I cut one of the ribs out, or the fact that the pulley's don't align...
Cliff notes
-S13 SR with S14 SR ps pump<
-Do the pulleys align
-Should I just get an S13 SR pulley?
My quesion is this : do the pulleys align? The first belt I bought was a 4 rib so I trimmed it down after the guy at Canadian Tire (napa) said it would work fine. (ya, don't try that, it doesn't work). I drive to the track ( about 2 hours) and not but 4-5 runs in the belt explodes.
So I'm not sure if it was the fact that I cut one of the ribs out, or the fact that the pulley's don't align...
Cliff notes
-S13 SR with S14 SR ps pump<
-Do the pulleys align
-Should I just get an S13 SR pulley?