steve_o1989
06-12-2008, 07:36 PM
I didn't know exactly where to put this, but I figure that since the fab thread is in here, this is as good as a place as any...
Anyways, this is taken directly from a thread on homemadeturbo.com. It is a tool created to determine the cuts and angles required to make specific pie cut suctions. Great for anyone looking to fab up their own IC piping, downpipe, or exhaust. It is laid out in the linked thread and there is a spread sheet you can save so you will always have it.
I though it was great to have so I figured I would share it with you guys because I'm sure alot of you could use it.
Here is the link:
http://www.homemadeturbo.com/forum/index.php?topic=79775.0
Anyways, this is taken directly from a thread on homemadeturbo.com. It is a tool created to determine the cuts and angles required to make specific pie cut suctions. Great for anyone looking to fab up their own IC piping, downpipe, or exhaust. It is laid out in the linked thread and there is a spread sheet you can save so you will always have it.
I though it was great to have so I figured I would share it with you guys because I'm sure alot of you could use it.
Here is the link:
http://www.homemadeturbo.com/forum/index.php?topic=79775.0