KA-T Oil lines..... suggestions please

[gotta240]

While i'm dropping a new ka i'd like to take care of the oil lines that i will need for my upcoming turbo kit.

I know there are countless ways of doing this with many different materials. So, based off experience, what is the best way to run the turbo lines while the motor is out?

IE:oil pan mods. What hardware should i be using, sizes, etc. I searched and didn't find much.

Thanks in advance.

[a_ghost]

get the jgs oil lines, they come with everything, including instructions. i got mine from them, then i just drilled into my oil pan...hahaha...

[clark]

you should look at unisa_jecs ka-t build. he did such a clean and nice job on his.

[gotta240]

http://www.jgstools.com/turbo/dlinst.jpg


Excuse my retardation. Can someone please take a look at this picture and tell me exactly what piece i need for the OILPAN ONLY. Can this piece just be welded to the stock ka oilpan?

I am a total fucking newb when it comes to fitting sizes... I just want to weld the correct fitting on NOW, so i don't have to pull the pan when i turbo in the future. THanks!!!

[dirtdiggler666]

i think jgs just sells it with bolth oil lines but if you call them im sure they will just sell you the return