patrickshofner
06-01-2008, 06:32 PM
I bought a 240sx that needed some work. I had planned on swapping out the auto that's in it for a 5 speed, but I don't have the time or the money to do the swap. I'm still new to the 240 world and don't really have the experience or know-how to complete this project. That's why I'm letting it go. I'm located in Louisville.
Came from a (I think) 1995 240sx. Approx 88k on Tranny. What's included:
Manual Transmission
Drive Shaft
Flywheel (probably should be turned)
Pressure Plate
Clutch (I would recommend a new one)
Crossmember
Slave Cylinder and line
Shifter
Brackets
I believe most of the bolts are here, but they aren't labeled. When I picked it up they were in a large McDonalds cup, and I haven't touched them.
*From what I understand, you WILL NEED a clutch pedal, master cylinder and line to complete the swap.
My email address is [email protected]
Came from a (I think) 1995 240sx. Approx 88k on Tranny. What's included:
Manual Transmission
Drive Shaft
Flywheel (probably should be turned)
Pressure Plate
Clutch (I would recommend a new one)
Crossmember
Slave Cylinder and line
Shifter
Brackets
I believe most of the bolts are here, but they aren't labeled. When I picked it up they were in a large McDonalds cup, and I haven't touched them.
*From what I understand, you WILL NEED a clutch pedal, master cylinder and line to complete the swap.
My email address is [email protected]