Rittmeister
05-28-2008, 08:10 PM
Edit: SOLD SOLD SOLD
As title states, short shifter for KA/SR manual transmission. I believe this will also fit the RB20 transmission. I've only used it for a couple months, and it's got a nice solid feel to it.
This is the ebay knockoff of a B&M shifter. I replaced the bushing at the bottom with a factory bushing - the one that came on it was too small a diameter for positive action. I filled some of the webbing around the edge with JB Weld so it would seal properly against the gasket on the shifter housing. I used RTV - scraped most of it off but that's the red stuff you see in the picture. I also drilled a hole on the passenger side to fit the middle bolt - when they made this thing they put the middle bolt-holes even from end to end, whereas on the transmission (and the stock shifter plate) the holes are slightly offset. With the hole I drilled you can get all six bolts in.
I'd keep this shifter but I got a great deal locally on a used B&M, so I jumped on it.
These seem to go on ebay from $50 (shipped) on up to $70-$80. I'm asking $40 shipped, including the good bushing.
Please PM if interested.
As title states, short shifter for KA/SR manual transmission. I believe this will also fit the RB20 transmission. I've only used it for a couple months, and it's got a nice solid feel to it.
This is the ebay knockoff of a B&M shifter. I replaced the bushing at the bottom with a factory bushing - the one that came on it was too small a diameter for positive action. I filled some of the webbing around the edge with JB Weld so it would seal properly against the gasket on the shifter housing. I used RTV - scraped most of it off but that's the red stuff you see in the picture. I also drilled a hole on the passenger side to fit the middle bolt - when they made this thing they put the middle bolt-holes even from end to end, whereas on the transmission (and the stock shifter plate) the holes are slightly offset. With the hole I drilled you can get all six bolts in.
I'd keep this shifter but I got a great deal locally on a used B&M, so I jumped on it.
These seem to go on ebay from $50 (shipped) on up to $70-$80. I'm asking $40 shipped, including the good bushing.
Please PM if interested.