PDA

View Full Version : 1992 240sx: will a tight parking brake cause pad wear?


surreybc
05-04-2008, 02:29 PM
If the parking break is adjusted too tight will that cause the rear driver side brake pads to wear fast? that is what is happening to mine and i have already replaced calipers , rotors on both sides of rear and problem persists

Firestorm
05-04-2008, 02:44 PM
is it just drivers side? at first i woulda guessed a seized caliper but then you said you replaced them...hmm...if your handbrake is adjusted too tight it would usually affect both calipers. but you can try and loosen it a little, problem is, short-term you probably wont see any effects.

surreybc
05-04-2008, 08:24 PM
is it just drivers side? at first i woulda guessed a seized caliper but then you said you replaced them...hmm...if your handbrake is adjusted too tight it would usually affect both calipers. but you can try and loosen it a little, problem is, short-term you probably wont see any effects.

I checked it today and the driver side is tighter . With the handbrake released , it is basically tight already on the driver side. on the passenger side, i have to move it a few inches before it gets tight.

Addicted2Kouki
05-04-2008, 08:31 PM
check if your driver side caliper is seized.

when mine was seizing up, the pads and rotors wore down fast...
but only on that caliper.

TanaMU
05-04-2008, 08:35 PM
Might have a stretched cable..