PDA

View Full Version : temp gauge gone wild


Timeattack
03-25-2008, 08:08 PM
I search a few overheating posts on here and ive found no one else with this problem. When i turn my heater on the temp gauge shoots up an inch in a split second, and it does the same when i hit the power windows up and down. Its kind of strange, when i turn the headlights on this does not happen. im guessing the temp sensors could be shorting out, but which one should i replace? their are 3 total correct? or is it something else? thanks

S13Leprechaun
03-25-2008, 08:12 PM
replace all three... might as well instead of foolin around... just do all three and see if it stops... done.

-s13lep.

Timeattack
03-25-2008, 08:18 PM
ill give it a try, thanks man

Sir
03-25-2008, 10:14 PM
ground issue - I'm like 99.99999999% sure

blu808
03-25-2008, 10:16 PM
Sounds like a ground issue as well. Those sensors dont usually go bad like that. they usually either work or dont.

Timeattack
03-26-2008, 06:03 AM
ground issue eh, ill trace all the wiring off the harness. thanks guys

DaPCWiz
03-26-2008, 06:34 AM
mine had strange issues like that when I first bought my 240. Literally, I took the temp sensor harness off, cleaned up the corrosion on the sensor / harness, put it back. bam, no more problem. This was the temp sensor by where the upper rad hose meets the block.

Timeattack
03-26-2008, 07:05 PM
mine had strange issues like that when I first bought my 240. Literally, I took the temp sensor harness off, cleaned up the corrosion on the sensor / harness, put it back. bam, no more problem. This was the temp sensor by where the upper rad hose meets the block.


I checked all my grounds and i sanded the paint off where the grounds touch the engine bay, this helped it a little bit it only does it sometimes now. ^^^Ill try this as well thanks guys