chibich
03-17-2008, 09:56 PM
I got my swap started a few months ago, but have since been up at school and not able to mess with it. I am going back this weekend and want to try and get everything fixed. The problem I was having was that it would start up and run for a little bit and then die (not like a vacuum problem, where it the idle fluctuate and then it dies out). I then unplugged the maf sensor and car would start up and run (rough),but it wouldn't die. Is this just a bad maf? (also didn't have the O2 sensor hooked up,which is part of the reason for it running bad), but is this just a bad maf? also the wiring harness that came with the motor didn't have a plug for the sr maf, so I used the ka maf plug and wired it that way? are these plugs interchangeable or do I need a sr20 maf plug too? (sorry for the newb questions, im used to subaru's so this is kind of a new territory for me)
does the maf wires also have to be covered, if so what did you guys use?
does the maf wires also have to be covered, if so what did you guys use?