wheel fitment question any assistance would be nice!

[sumfknguy]

looking at a set of Work Equips for my s13 hatch. size are 18x9.5+8 114.3 5 hole and 18x11+24 114.3 5h what you guys think? i dont want flares but wouldnt mind pulling the rears or cambering in some and some stretched tires. but would like to know if it would fit over my z32 calipers and 350 rotors up front without spacers.... thanks in advanced and if they fit i'll buy someone here coffee =)

[sac]

NOT to be rude, but they have a sticky wheel fitment guide thread. READ that. Ask your questions there. You will get better response.

[i need tires]

just check the wheel fitment thread... find something close to the sizes you have here and you will know what needs to be done! but most likely you will need to do some kind of roll unless you have EXTREME negative camber front and rear, and yes these sizes should clear z32 calipers

[KA-T_240]

There is a 30+ page thread on this that is a sticky. I am nice so....

http://www.zilvia.net/f/showthread.php?t=129865
http://www.zilvia.net/f/showthread.php?t=166626

[exitspeed]

There is a 30+ page thread on this that is a sticky. I am nice so....

http://www.zilvia.net/f/showthread.php?t=129865
http://www.zilvia.net/f/showthread.php?t=166626

That was awful nice of you.

:lockd: