Has anyone noticed this???

[nissans14k]

hey guys, im installing some OEM cams on my ka and i was doing a bit of research...well, i found a installation from JWT on a cam how to install and they were saying to torque the bolts from the Center out to 6.7 to 8.7 ft-lbs. and on the FSM it says to bolt them outward in.... is it just because its there cam or is that the real correct way to install em... i just noticed this so if someone could shed some light on this, that be great.

[90KAcoupe]

they come off from outside in and u put them on going from the inside out. but normally u have to run them down according to how u have them set. just be sure u run the caps down evenly all the way across and u should be fine.

[KA-T_240]

I would fallow the FSM. It has a guide for doing them.