View Full Version : RB mount question.....
((sr)) kelly
03-05-2008, 08:19 PM
i just ran across an AMAZING deal on a set of McKinney Mounts off a Rb20det for a s13
are these mounts compatable with the Rb26dett? i have looked EVERYWHERE for info, and looked on the McKinney website and there is no distinction between any of the RBs... they are all the same price, they all Look the exact same, they all weigh the same.. etc...
thanks
no there not, mack explained this to me personaly, and ive seen the mounts together and the geometry of the two are completley different.
((sr)) kelly
03-05-2008, 08:48 PM
are the rb20s and 25s compatable?
there all different.. sets the motor in the correct possition to clear the hood, and other key points on the purpose of designing 3 different motor mounts. for three different motors.
!Zar!
03-05-2008, 08:58 PM
You need more than motor mounts. You need the subframe, the driveshaft, and not to mention the engine and whatnot.
HyperTek
03-05-2008, 09:21 PM
give it up.. rb is wack!! rb+s15 front was the fanboy dream car of early 2002 lol
pretty sure they are all specific.. since they dont advertise just one fitting all
96Turbo
03-05-2008, 09:46 PM
You need more than motor mounts. You need the subframe, the driveshaft, and not to mention the engine and whatnot.
subframe???? You might be thinking crossmember (skyline), which in fact is not required with the McKinney mounts. Stock crossmember is utilized
((sr)) kelly
03-05-2008, 09:55 PM
^ is correct...
all i need to sqeeze the rb26 in is McKinney mounts and new drive shaft..
im just tired of my sr20.. it has NO torque... and soooooooooo many people have them..and i can part mine out to cut the price of what the swap is going to take big time...
thanks guys!
vBulletin® v3.8.11, Copyright ©2000-2021, vBulletin Solutions Inc.