PDA

View Full Version : S13 SR auto harness to 5 speed moor set problem?

JDS Performance
03-04-2008, 05:25 PM
I am trying to figure out what to do with the s13 auto SR harness on a 5 speed s13 SR motor set

The TPS connector is different - I am not to sure of there is more different or not? Help please.

I looked at the s13 SR auto harness (6 pin) TPS plug - verses the s13 SR 5 speed (3 pin) TPS plug

There are 3 wires on the auto plug that are the came color as the 3 wires on the 5 speed plug.

Can I just repin the 5 speed plug onto the auto harness and not use the 3 left over wires and all will work correctly?

I would look at the FSM's pin out but I do not have a FSM for the s13's ECU pin outs - if anyone has or knows where to get one - I would be much greatful!

Please help thanx!

Auto TPS Plug
http://i82.photobucket.com/albums/j274/joshds25/DSCF0002-20.jpg
http://i82.photobucket.com/albums/j274/joshds25/DSCF0003-17.jpg

5 Speed TPS plug
http://i82.photobucket.com/albums/j274/joshds25/DSCF0008-13.jpg
http://i82.photobucket.com/albums/j274/joshds25/DSCF0006-19.jpg
http://i82.photobucket.com/albums/j274/joshds25/DSCF0010-13.jpg
JDS Performance
03-05-2008, 07:49 PM
Nevermind - I figured it all out tonight - so if anyone comes on this thread later and has the same question I did - here is the answer;

Use the white wire from the auto tps plug to where the white wire goes on the 5 speed tps plug

Use the black wire from the auto tps plug to where the black wire goes on the 5 speed tps plug

Use the light green wire w/ red stripe from the auto tps plug to where the light green w/ red stripe wire on the 5 speed tps plug goes

So basically you are just swapping color for color between the 2 plugs and whats left over cut them at differnt lengths (so the dont short out) and tape them up into the harness (to hide and keep safe from shorting out)

I will add pix later on.

I finally found a s13 sr20det ecu pinout - to justify if this was correct or not.

If anyone has any questions about this LMK I will help as much as I can.
Flybert
03-06-2008, 12:03 AM
They won't short out because they run to the automatic computer plug that is near the ECU plug.
JDS Performance
03-06-2008, 04:42 AM
They won't short out because they run to the automatic computer plug that is near the ECU plug.


ahh ok thanx man!
fairladysx_s13
07-25-2008, 10:05 PM
ecu pinout? im in need. i wired the tps like this and sometimes it works and sometimes it doesnt. so im just ganna hard wire it.