where to find banjo bolts.

[burnsauto]

(NOT SURE IF IN THE RIGHT SECTION, PLEASE MOVE ACCORDINGLY :bigok: )

ok guys, I've noticed a lot of people always looking for banjo bolts, weather it be for oil feed lines, or the turbo's themselves.

http://www.slowboyracing.com/estore/product.php?productid=1919&page=1


BAM, there you go. I found out that the oil feed banjo bolt is the same size and thread pitch as 1st gen dsm guys. (after about two days of poking around...) So, from me to you, another resource that you guys can use. They also sell copper crush washers for teh cheap, so all you need to know is the size and pitch of the banjo bolt you need...and you're good to go.


.. and before I get a bunch of replies about atpturbo.com, yes..i know they carry them as well.. but I'm not sure if they carry the size we need for the oil feed line. (could be wrong.... never looked that hard.)

-Jared

[superJoy]

Here's another tip: if you're in need of copper washers, Harbor Freight sells a variety pack thing for like $10. They're not metric sizes, but they're close enough that they'll work in a pinch. I've got some on my high pressure P/S fitting that goes into the pump, no leaks!

[LongGrain]

haha, i thought this thread was ASKING where to find them, and i was going to suggest slowboy racing.

i guess your a step or two ahead of me.
+1