My clutch went bad

[NiteKids]

After a nite of donuts and drifting in a parking lot with a few friends my clutch wouldn't come all the way back up. Only would come up like 1/4. Car seemed to for the most part drive okay on the way home but didn't seem to fully disengage with it down. Well a few stop lights before I get home I put down what little clutch was comming back up and it wouldn't go in gear at all. So I some how pull it into a gas station. So after awhile I could drive it again. So pretty much one light before I get home I downshift to second to make the turn and on that down shift the clutch goes allllll the way to the floor and doens't come back up at all. Now there way no clutch pressure at all so I some how cruised home in second and died in my drive way..

So pretty much anyone know what the problem could be?

Also let it be known that durring the time of fun and stupidity I never acually dropped the clutch.  All the breaking lose was from a hard shift from 1st to 2nd gear.

[Grant]

you need to get your clutch replaced.
your master cylinder or slave cylinder might have went
your clutch pedal broke
you're an idiot. <img src="http://www.zilvia.net/f/iB_html/non-cgi/emoticons/lookaround.gif" border="0" valign="absmiddle" alt=':look:'>

[drifterx]

it could be the master cylinder but it also could be as simple as the clutch bracket breaking..... which is a common problem in the 240sx......
good luck check a few old post i had and some other ppl had abt the bracket

[NiteKids]

Maybe it could have been my Clutch Connecter brace that caused the whole problems?
http://members.aol.com/Ryoga35510/broken.jpg

[MorganS13]

i'm having almost the same problem. &nbsp;i woke up this morning and went out and tried to start my car and it just stuttered and ran like crap like i was still in gear (had clutch down). &nbsp;i put it in neutral and it ran fine. &nbsp;my clutch does not work at all anymore... &nbsp;basically i've been told its my slave ($20) or master cylinder($60). &nbsp;i just purchased a slave cylinder and i'm going to check to see how my bracket is tommorow after hearing what u guys said. &nbsp;good luck

[NiteKids]

What is the red circled part called. &nbsp;That's the exact part I need to repalce.?

http://members.aol.com/Ryoga35510/part.jpg

[96SEChick]

If that diagram is what I think it is, that's the same thing that broke on my car last year. &nbsp;The shaft for my clutch master cylinder was actually broken, causing my clutch pedal to go to the floor and only come back like 1", which makes it really, really uncomfortable & a total bitch to shift.

It cost me $250 to have the clutch master & slave cylinders replaced my favorite Nissan dealership (I went ahead and had the slave replaced for no extra labor fee).

Good luck!!

[BadMoJo]

ha!


damn, same part snaped on my car about 5 months ago!

Its just that "U" shaped clip you have shown. But the dont sell it by itself it seems, you neeed it get the whole rod with the "U" at the end. It cost $11.00~~ But all you need is the clip. So when you get it. Just take the "U" off the end of the rod, and remove the broken one. Replace it and adjust it to where the clutch take up feels normal again.

Your lucky, I thought it was my clutch as well untill I looked up there and saw the busted "U" clip.