Camber Plate Hex Bolt Torque Spec?

[samms95s14se]

Wondering if anyone knows if there is an actual torque spec for the 4 hex/allen key bolts on the sliding plate that adjust the front camber? I've searched but never found anyone mention this anywhere or is it tighten until nice and snug? I have some front Tein plates I need to put on my Agx's soon. Thanks!

[samms95s14se]

Bump. So I must not be the only one who doesn't know an answer to this question?

[Def]

Just snug them. They're not a very big bolt - I imagine the actual torque spec is somewhere in the 10-15 ft-lbs range given the size.

Unless you have a very nice torque wrench, it probably isn't accurate down to that low of a torque value, so just go by hand. It's actually more accurate if you are halfway thinking about how much force you are applying and the lever arm length.

[burnsauto]

tight is tight.

just as long as they dont move..you're good. if they move...tighten them down more.