Z32 Cables for S13

[Rod]

Hi Guys, hope you guys can help. I've been looking and no one seems to have a clear-cut answer to this.

Just picked up my good friend Carlos Doria's rear Z32 brake setup with drums and calipers. I have a S13 Hatchback and don't know what cables to use. I've read people using Z32 cables - but which one? 2+2, 2 seater non-turbo, 2-seater turbo?

I called Nissan and they have 2 different part numbers for each side of the 2-seater non-turbo:cry:

any help will be very appreciated!

thanks guys,
Rod

[UNISA JECS]

S13

I've heard people on this forum say that 2+2 are to long and by the same token that they fit just fine (go figure), and the 2 seater cables I've heard that they fit better than the 2+2 because there shorter and I've heard that they dont reach at all, until I quit being lazy and figure out if they truely do bolt on I can't help much.

Ask Vutony I think he used 2+2 cables, I think he said they bolted right up like stock so i'd start there I know he has a S13.

[Addicted2Kouki]

If i remember correctly, It was 2+2 for s13.

Sounds right.

[UNISA JECS]

I just wanna see a picture of them fitting like these (bolt-on after modifying (these are my modified cables pictured below) but from a Z32 2+2 or 2 seater on a S13 chassis unmodified:

http://i167.photobucket.com/albums/u159/zilvia_album/P1140004.jpg

[MELLO*SOS]

yeah one of my 2+0 cables fits perfect. the other is about 4-6" too long (pass side) wtf.. Fixing this weekend hopefully...

[ManoNegra]

Shorter ones re-route, longer ones fit on stock location.

[Rod]

thank you everyone for the help - Vutony shed some light! Thanks man

UNISA JECS - thanks for the referral. He uses Z32 2+2 and he said it bolts right up

thank you all!
Rod