Tranny and pressure plate bolts

[yarou]

I've lost a couple of both, and considering getting same sized bolts from orchard supply. Any negative shit that would make me reconsider? Peace of mind? Aliens? Should I just order them from nissan and wait a week?

[Dousan_PG]

tranny bolts are extremely hard to find
theones that go bellhousing to block

the pressure plate i would just get from dealer
they dont cost that much

[UNISA JECS]

Here this should help you out, BTW there is one bolt that is no longer available threw nissan can't remember which one but after I do my auto to 5 speed I will.

http://i167.photobucket.com/albums/u159/zilvia_album/P1200010.jpg

[UNISA JECS]

Heres teh actual number count you need of each item, though some items require you to buy the whole bag.

http://i167.photobucket.com/albums/u159/zilvia_album/scan0001.gif

[projectRDM]

The pressure plate bolts are easy to get anywhere, they're a common size. The bellhousing bolts aren't as easy to find, but you don't need all of them anyway. The lower four do nothing except hold the lower brackets from the block, I remove those on every car I do so those bolts are obsolete. Then I don't use the two uppermost bolts either, makes getting the transmission back a lot easier when it's in the car. After that, you only need maybe six, three on each side, two of those are for the starter.

[cronux]

its good to know that the bottom 4 arent needed, as thats what i assumed. i actually got some of my tranny bolts from advance, i had the pitch/thread, and length, and they have length increments of 10mm, so i just got the ones that fit. it was cake.

[UNISA JECS]

I thought this picture would be good reffeernce here, you can also tell pretty much where my bolts in the picture above go by the quantity and by the use of nuts in teh below picture:

http://i167.photobucket.com/albums/u159/zilvia_album/SP32-20080122-100131.gif

[UNISA JECS]

Pressure plate bolts and flywheels bolts:

http://i167.photobucket.com/albums/u159/zilvia_album/P1200001.jpg