Question reguarding the Z32 MBC.

[SSMini]

Just installed the complete z32 brake upgrade on my s13. I pulled the parts off a 90-91 NA z32. I did a search using "z32 MBC" and came up with 2 pages and the info I needed was not there. The brake fluid level wiring is what I need to double check. My oem plug, plugs in the z32 MBC, but not sure if the wiring on the plug is the same or not. Can someone verify this for me?Thanks.....

[KA-T_240]

I just have mine plugged in. I guess the light doesnt stay on all the time or anything. I also check all my fluids at least once a month, no consired about getting fluid.

[Skullavera]

It should be fine. Just plug in play.

[rlpinoy]

i think that plug is just a sensor to tell you if you are low on fluid. mine got disconnected and my brake light stayed on and that was it.

[projectRDM]

It just completes a circuit, it doesn't matter if the plug is backwards or anything else. Once fluid level reaches low, contact is made across the pins. Same as a light switch in a house, you can mount it upside down if you want, all it does is connect an input to an output.

[g6civcx]

The brake fluid level sensor has 2 wires. When the fluid is above a certain level, there is no continuity. When fluid falls below a certain level, there is continuity between the 2 wires. That's it.

One wire goes to the brake warning light and the other wire goes to ground. When the bulb sees ground it will light up.

[SSMini]

Thanks for the info guys....