Nardi install in progress, 1 quick question

[khilgers]

I'm in the middle of installing my Nardi wheel, WB hub, and WB Rapfix II quick release. I had 1 ? concerning the resistor that is included to cancel out the airbag warning light. The hub and quick release came with 2 different resistors. 1 with a clip on the end, and another with just the fuse and 2 prongs. I used the 1 with the 2 prongs and inserted it into the factory SRS harness.

My ? is does it matter which way the resistor goes, I would imagine not since it is just sending a signal through the fuse and back. Heres a pic, and I also just wanted to make sure I had the other wiring correct. Let me know if you see anything out of the ordinary.

http://www.khilgers.com/forumpics/wheelinstall1.jpg
http://www.khilgers.com/forumpics/wheelsinstall2.jpg

[deesz]

no it does not matter what way the resistor goes it is not a diode. it is a resistor it resist in any direction.....
as for everything else it seems fine but kinda hard to tell from pictures

[MA JasonG]

^correct, and it looks like your ok on the rest of the wiring.

[deesz]

i actually have a Question.. did you measure the resistance of the resistor
there was a Q asked earlier about how to turn off the airbag light.

[azndoc]

I'm not too $ure $ince I've never in$talled the WB and not on a $14.

I'm $ure the be$t per$on to a$k would be Logan at A$pec.

He know$ hi$ WB $hit.

[Fries]

I'm not too I've never in the WB and not on a $14.

I'm the be per to a would be Logan at A.

He know$ hi$ WB .

You missed one :bigok:
+1 for a question that I'd soon be asking!

[94cc0rd]

actually since its dealing with s14s you should definately talk to Tuan over at aspec... but from the one picture I can see... it seems like you've got everything right... tuan helped me install my wb hub too.

[sTalnOut]

whats fuse are you using to connect together?

[4bangers]

so QR also comes with resister for SRS light? I thought just the hub does that?

[downshift_sideways]

It does not matter which way you clip the resistors.

Your wiring is all correct.

[-the.k.w.c-]

i didnt even add anything onto the air bag light wire when i did my momo wheel the air bag light went off after i left the battery off and it reset the ecu