CSXTacy
12-05-2007, 02:13 PM
Ok every one i know as soon as i post this there will be 50 replys saying search, search, search! but i have searching for a while to no solid answer. so if you could save me the hassle of being harassed for not searching and just give me some good info that would be greatly appreciated.
I have a Redtop SR and the MAF sensor that came with the motor sway has taken a dump on me so it is time to get a new one. now i searched the forums to see what kind of MAF sensor i could use to replace my old one. and it seems like the consensus was a 89 240sx SOHC MAF sensor will work. so i went down to my local autoparts store and purchased a MAF for a 89 240sx SOHC well when i recieved the item it only had a 3 prong plug in. i know that only three are used on the Sr motor swap but i am sure the connector has a fourth pin that is just empty. so i guess my question is did Orilies send me the wrong MAF or do i have to cut the plug off of a stock KA harness or is there another MAF sensor that will work that has a connector for 3 wires but is wide enuff for a 4 wire connector? i hope this is clear enuff for everyone. sometimes i get off track with my posts. Like i said i did search the forums but found too many post saying too many different things. anyones info would be greatly appreciated!!!
I have a Redtop SR and the MAF sensor that came with the motor sway has taken a dump on me so it is time to get a new one. now i searched the forums to see what kind of MAF sensor i could use to replace my old one. and it seems like the consensus was a 89 240sx SOHC MAF sensor will work. so i went down to my local autoparts store and purchased a MAF for a 89 240sx SOHC well when i recieved the item it only had a 3 prong plug in. i know that only three are used on the Sr motor swap but i am sure the connector has a fourth pin that is just empty. so i guess my question is did Orilies send me the wrong MAF or do i have to cut the plug off of a stock KA harness or is there another MAF sensor that will work that has a connector for 3 wires but is wide enuff for a 4 wire connector? i hope this is clear enuff for everyone. sometimes i get off track with my posts. Like i said i did search the forums but found too many post saying too many different things. anyones info would be greatly appreciated!!!