quick help on avc-r

[jdFKNmVRT]

i was installing my avc-r and had a quick question just got to make sure i'm correct... i had a blitz boost controller previosly installed and from the boost solenoid one port goes to the actuator and the other to the piping on the intercooler... So does this also apply for the avc-r cause the COM port from the avc-r goes to the actuator and the NO port does it also connect to the intercooler piping???:stupid: sorry.

[skylindrftr]

the instructions should make it very clear

[jdFKNmVRT]

its kinda confusing me... thats the last thing i need to connect. i got it to the intercooler piping right now but i think its wrong.

[skylindrftr]

well what is that vaccum line reading? the reason most bc's have that is so they can get a pressure reading from the i/c piping or better yet the compressor housing.

[jdFKNmVRT]

okay the avc-r comes with a pressure sensor that taps into the nipple that connects to the fpr... So back to my question where does that NO port line go???

[skylindrftr]

like i said in the instruction manual there should be a diagram that shows it, i have installed one on my friends evo but i do not remember where it goes, we just went by the diagram in the manual.

[jdFKNmVRT]

disregard this post... i figured it out. thanks.