View Full Version : Tru Boost Setting Questions
sleepinsilvia23
10-30-2007, 08:12 PM
I am looking for good AEM tru boost settings that would put me at around 12 PSI. I have had little time to try and play with the settings and i dont know if i made much progress. So if any of you have good settings on a pretty much stock reptop that would put me at 12 psi let me know, or if any of you are tru boost experts i could use your help.
Thanks
pearlwhiteS14
11-01-2007, 10:03 AM
This info would get great!
SixSpeedSleuth
11-01-2007, 02:29 PM
Just keep raising the percentage in 2 percent increments until your boost gauge reads 12 psi. Just remember, you might not see any gains until you have the setting at 35 or so. If I set mine to 50, I run around 18 PSI, but I have a completely different setup then you do.
sleepinsilvia23
11-02-2007, 10:12 PM
Right, i understand taht but theres alot of different setting that can be played with you know?
Edcel
11-03-2007, 02:09 AM
i have a the aem tru boost controller/gauge and its good, does the job. basically when you set your gain in the A or B setting its thats number you set is the percentage of your factory wastegate setting. eg: stock t25 is 7psi so if you set setting A to 50, your boost controller should read 10.5ish psi. therefore if you want 12psi and youre running a stock t25 it should be set to roughly 65-70. pm me if you got any problems or questions.
srdet811
11-08-2008, 12:14 AM
My current set up is a stock s14 t28 turbo
jim wolf ecu
nismo 744 injectors
300zx maf
walbro 255 fuel pump
300zx fuel filter
apexi intake
i want to run 12 pounds of boost.
what should my spring rate SPr should be
what should be my scramble boost SCb
what should be my scramble boost time SCr
what should be the value next to my Axx setting
im looking to run 12 pounds of boost
vBulletin® v3.8.11, Copyright ©2000-2021, vBulletin Solutions Inc.