Slave cylinder question

[98koukile]

The FSM doesn't have the answer im looking for... where the rubber line seats on the slave cylinder there is a slight depression. It looks as if there's supposed to be a copper gasket or something filling that void, anyone know off hand if this is the case? I could always use silicon or something of that nature but with fittings like that copper just makes sense. Thanks in advance for any insight

[98koukile]

C'mon guys I know someone whos done the swap or removed the dampener has run into this... I need to know by tomorrow morning

[zaneithan]

i know i just put my slave on and a nismo stainless steel clutch line and i used a copper washer in between the line and the slave, hope that helps

[98koukile]

Yeah thats what I suspected I needed, thanks

[X 350GT X]

to re-assure you there, i just did that this weekend. yes, there is a copper washer like the person above stated. the washer was 57 cents at my local nissan dealer.