My cas, i just ordered, has no color dots

[unwtdhero]

i have searched and searched but no one has this problem. my cas has no color dots, how i determine where to align it to?? although it has the pin that goes through the shaft, help please, ill give rep.

[Sileighty_85]

Ok when installing the CAS There are two dots next to eachother with the gear pointing away from you the Left dot should be the Yellow one so when installing it line up the right Dot (Not Yellow) with the "slit mark" (while engine is @ TDC #1Cylinder ) and when you install it it will rotate to the Yellow dot. So the Yellow Dot should line up with the Slit Mark after Install. Bam your done

[Pank]

didnt he just say there were no colored dots?

[Sileighty_85]

I told him the two dots next to each other the LEFT ONE WAS THE YELLOW ONE!

read it closer next time

[McCoy]

If you don't have the colored marks on your CAS, do you have an indent? My S13 DE did not have the colored marks but did have an indent to use to align the CAS

A picture of mine...
http://www.sr20forum.com/gallery/data/959/medium/JWT_S3_04.jpg