Sard injector connectors??

[sunnys14]

i have a set of sard 550cc injectors and they arent compatible with my KA harness connectors. ive seen some people say you can use some off of early 90's toyotas. any other options??

[garbury]

I just crimped the metal clips that come with the injector clips onto the injector wires. My sard injectors came with them.

But yeah apparently you can just get the injector clips from older toyotas (I believe most, just bring an injector with you to a junkyard). Then the metal pin crimped to the wire just pops out of the nissan clip and pops right into the toyota clip and you are good to go without messing with wires. If I knew this, I would have done it rather than butcher my injector harness.

There is an orange retainer on the nissan clip, you have to play with that with some kind of sharp scribe-like tool and pop that out. Then you can free the wire by prying up its catch point with the same scribe tool and just pull it out. It will then just snap into your new toyota clip and you should be solid.

[sunnys14]

if i am going to just use a toyota clip on, does it matter which side is wire is positive and which wire is negative?

[AceInHole]

I don't think it makes a difference which side is positive or which is negative, as it's simply an electromagnetic solenoid. Although, don't quote me on that....

Anyways, I've heard Subaru Denso-style side feed injector clips also work. I used new ones though. The only place I found them was:

http://www.fiveomotorsport.com/Injector_CONNECT.asp
http://www.fiveomotorsport.com/PartsJPEGs/Injectors/ConnectDenso1.jpg