Thread size and pitch for z32 caliper

[Whiplash Willy]

I am in the middle of installing Z32 26mm calipers on my 240sx. I am missing the hardline that goes between the caliper and my brake line. I want to get a Male to Male adapter for the caliper to the line, but can't figure out the thread size and pitch for the caliper. I can't find this information anywhere...can someone help me out?

[brian m]

just get the conversion lines from P2M, spl or frsport. No need for the hardline.
or read this post http://www.zilvia.net/f/showthread.php?t=154139

[Whiplash Willy]

I already have the lines, I just need the M 2 M adapter between the line and caliper. I rather not spend $80 on lines when I can just spend $10 on adapters.

http://www.beefstorm.com/pics/240pics/300zbrakes012.jpg

That thread doesn't list the thread pitch and size, just the size of the wrench he used to tighten the adapter and line.

[Sir]

IIRC its an inverted flare to -3an. Something like that.

[nassin31spr]

The piece in the picture is a 1/8npt to -3 or -4an. Take the bolt and hose to your local hardware store and they can measure it for you. I know the part that screws into the caliper is 1/8npt though.