t67s13
08-18-2007, 08:18 AM
Chassis has 117k or so clean title interior and exterior are about 6 out of 10.
Looking to get 8k
Mods are:
Engine: Red top SR fully rebuilt 3k ago
- Apexi head gasket
- Arp head studs, main studs, rod bolts
- All new OEM bearings, rings, Gaskets ECT.
- New oil pump, water pump, Timing chain
- Greddy oil pan
- Greddy valve springs
- Hks step 1 264 cams
- Head has full valve job all gone through
- Greddy intake manifold w/ Pro Fab Design plastic intake manifold gasket
- Nismo engine mounts/ trans mount
- Top feed fuel rail w/ msd 740cc injectors
- Aremotive FPR w/ AN lines
- New S15 turbo w/ taka lines
- Greddy o2 extension and down pipe
- Buddy club spec 2 exhaust
- Walbro 255 fuel pump
- Z32 MAF
- Koyo w/ FAL dual fans & samco hoses
- Greddy M-Spec FMIC
- Full custom engine harness all wrapped and tucked
Trans:
- Stock flywheel
- Drive shaft shop 1pc drive shaft
- Exedy stage 2 clutch
- All new lines, slave cylinder, master cylinder
LSD:
- Tomei Tech Traxx Advance 2 way
Electronics:
- Apexi power FC w/ commander
- Blitz sbc i-d boost controller
- Blitz DC Oil pressure meter
Suspension:
- Stance GR+ Pro coilovers
- Tension Rods
Wheels:
- 5 Zigen FN01R-C 17x9 + 15 w/ 225/45/17 front Bronze
- 5 Zigen FN01R-c 17x10 +12 w/ 235/40/17 rear Bronze
http://img53.imageshack.us/img53/8158/1434318ay3.jpg
http://img171.imageshack.us/img171/4954/s14as2.jpg
Looking to get 8k
Mods are:
Engine: Red top SR fully rebuilt 3k ago
- Apexi head gasket
- Arp head studs, main studs, rod bolts
- All new OEM bearings, rings, Gaskets ECT.
- New oil pump, water pump, Timing chain
- Greddy oil pan
- Greddy valve springs
- Hks step 1 264 cams
- Head has full valve job all gone through
- Greddy intake manifold w/ Pro Fab Design plastic intake manifold gasket
- Nismo engine mounts/ trans mount
- Top feed fuel rail w/ msd 740cc injectors
- Aremotive FPR w/ AN lines
- New S15 turbo w/ taka lines
- Greddy o2 extension and down pipe
- Buddy club spec 2 exhaust
- Walbro 255 fuel pump
- Z32 MAF
- Koyo w/ FAL dual fans & samco hoses
- Greddy M-Spec FMIC
- Full custom engine harness all wrapped and tucked
Trans:
- Stock flywheel
- Drive shaft shop 1pc drive shaft
- Exedy stage 2 clutch
- All new lines, slave cylinder, master cylinder
LSD:
- Tomei Tech Traxx Advance 2 way
Electronics:
- Apexi power FC w/ commander
- Blitz sbc i-d boost controller
- Blitz DC Oil pressure meter
Suspension:
- Stance GR+ Pro coilovers
- Tension Rods
Wheels:
- 5 Zigen FN01R-C 17x9 + 15 w/ 225/45/17 front Bronze
- 5 Zigen FN01R-c 17x10 +12 w/ 235/40/17 rear Bronze
http://img53.imageshack.us/img53/8158/1434318ay3.jpg
http://img171.imageshack.us/img171/4954/s14as2.jpg