Aero-Catch Hood Pin Install?

[steve shadows]

Do we already have a thread for this?

I looked but didnt see anything.

I have an s13 of course, I need to install these bishes, anyone have any tips or pics on preferred mounting location.

how did you cut your hood? (ive got a VIS CF).

Thanks guys.

[trybal]

i have them and am having a hard time deciding to cut into my 1 of a kind hood.. haha :(

[fromxtor]

http://aerocatch.com/AeroCatch-Brochure.pdf

[mrj355]

http://www.nicoclub.com/articles.php?id=206434

[Slidin240Wayz]

Steve,

I had a minor issue with lining them up correctly.

I cut the initial hole on the inside part of the hood ok, but then I used the stencils on the top part of the hood while the pins were resting underneath.

I cut the holes as is, and when it came time to latch the hood, the hood pin holes were too high by 2-4 mm, causing me to cut the hole lower into the hood and creating a gap on the high side.

When it comes times for you to cut the holes on the top section of the hood, set your templates up with the pins poking through the top part, and set the template down 3mm.

Carlos

[steve shadows]

Steve,

I had a minor issue with lining them up correctly.

I cut the initial hole on the inside part of the hood ok, but then I used the stencils on the top part of the hood while the pins were resting underneath.

I cut the holes as is, and when it came time to latch the hood, the hood pin holes were too high by 2-4 mm, causing me to cut the hole lower into the hood and creating a gap on the high side.

When it comes times for you to cut the holes on the top section of the hood, set your templates up with the pins poking through the top part, and set the template down 3mm.

Carlos


thanks these are kind of tips im looking for.
http://www.nicoclub.com/articles.php?id=206434



and thanks for this, ive never been on nico

[DOOK]

thanks these are kind of tips im looking for.




and thanks for this, ive never been on nico

i bet that breaks your heart too doesn't it :D

[brokeAs240sx]

and thanks for this, ive never been on nico

It's also a thread somewhere around here in the tech section ;)