What u know bout' that gt35r

[DDSR240]

Hey Thanks looking Im Building up my blk top sr20det. So what Im asking 4 is some advise and input on my set up, here it is....... GARRETT-GT35-R A/R.82/E-BAY TOP MOUNT MANI/TIAL 38MM EXTERNAL W/G ARP HEAD STUDS/ B/C VALVE SPRINGS AND TI-RETAINERS,264 CAMS/COMETIC 1.2HEAD GASKET GREDDY NOCK-OFF INTAKE MANNIE/HKS740CC INJECTORS/GREDDY RAS/MILD PORT-POLISH 3ANGLE VALVE JOB/NEW VALVE SEALS AND GUIDES/ J-30 LSD / SHORT THROW SHIFTER/ TURBO SMART DUEL STAGE BOOST CONTROLLER / E-BAY 31*3*24 3INCH INLET AND OUT / WALBRO255. THATS ABOUT IT LIKE i SAID ANY IMPUT WOULD BE APPRECIATED LIKE GHOST HORSEPOWER RATINGS PARTS NEEDED /NOT NEEDED THAT SORT OF THING THANKS.:2f2f:

[DDSR240]

just got lightwieght pullys nock off greddy oil pan and AEM w/uego 30-1600u

[max_POWER]

caps lock much? sounds like a nice set up man, but the question is, what do YOU know about that GT35R?

[fliprayzin240sx]

Better question is who the fuck is tuning it? What kinda cams are they...264 dont mean jack shiet when you the lift sucks...

[DDSR240]

sorry no i don't caplock much, and there .475 inches or 12.06 mm. My fidanza flywheel is comming in next week but im still undecided on a clutch. compitition,act,or the expensive exedy. any advise weather I should use a sprung or unsprung disk.

[DDSR240]

sorry its not a a/r 82 its a a/r 70 its a .82 trim

[DDSR240]

and to answer the other question the cams are b/c too.

[DDSR240]

Also any body know whatwould be thi best diameter exhgaust to run

[skylindrftr]

plz run at least 3.0 in all the way back

[MavericStephenc]

run a gtspec from apexi I had mine for like 2 years and i swear by it. it goes from 75mm to 95 mm to 115 mm great flow. as for the manifold I would fun a full race setup if i had the cash.ditch the knock off stuff like the oil pan, in the end you get what you pay for.

knock off intake manifold? dude spend money right the first time.

[DDSR240]

I understod that the greedy nock off oil pan and intake were the same PLZ tell me the differances. Sorry but I can't afford all good stuff but the AEM ECU and garrett gt35r broke me

[MavericStephenc]

probably the quality in build fitment product backing ect.....