Gilboyto
08-08-2007, 04:30 PM
So basically I dont want to sell it, but I need the money definitely. there is nothing done to the motor, it runs. Its a KA24E single cam slammer. Only thing engine wise that I did was stick my buddy club spec II catback on it with a hollowed cat. It sounds good...lol. Anyways, Everything else it stock, there are Infinity reference and kappa 4x6 speakers front and rear, but there is no deck because I put it in my new daily.
Other mods are as follows.
Energy Suspension full polyurethane kit front and rear ($250)
JIC FLT-A1 coilovers with 8K front and 6K rear spring set ($1,200)
SPLParts RUCAs with pillowball mounts ($250)
Suspension Techniques front and rear swaybars ($275)
Momo Corse RPM wheels with Nitto Neogen tires ($1500)
Then the normal tint to survive NM, etc...
There is a dent in the drivers rear quarter panel from the previous driver. I purchased this to do an LS1 swap, but ran short because of money and school coming up. Everything runs, of course it has its small issues because it is 18 years old, but runs just fine with no major issues. This could easily be a drift setup car, most of the suspension is already done.
I purchased this car in WA, for $3500, with all the suspension, wheels etc I am looking to get $4,000 OBO.
This car is titled in WA, and where I lived there was no emissions necessary, it has a clean title, just needs to be transferred to NM.
With questions, e-mail me at [email protected] subject 240SX or similar so I can see it.
Thanks!
Nathan
When I first got it...
http://i96.photobucket.com/albums/l162/Gilboyto/750A0038.jpg
After suspension...
http://i96.photobucket.com/albums/l162/Gilboyto/DSC05347.jpg
Coils and RUCAs....
http://i96.photobucket.com/albums/l162/Gilboyto/DSC05428.jpg
Other mods are as follows.
Energy Suspension full polyurethane kit front and rear ($250)
JIC FLT-A1 coilovers with 8K front and 6K rear spring set ($1,200)
SPLParts RUCAs with pillowball mounts ($250)
Suspension Techniques front and rear swaybars ($275)
Momo Corse RPM wheels with Nitto Neogen tires ($1500)
Then the normal tint to survive NM, etc...
There is a dent in the drivers rear quarter panel from the previous driver. I purchased this to do an LS1 swap, but ran short because of money and school coming up. Everything runs, of course it has its small issues because it is 18 years old, but runs just fine with no major issues. This could easily be a drift setup car, most of the suspension is already done.
I purchased this car in WA, for $3500, with all the suspension, wheels etc I am looking to get $4,000 OBO.
This car is titled in WA, and where I lived there was no emissions necessary, it has a clean title, just needs to be transferred to NM.
With questions, e-mail me at [email protected] subject 240SX or similar so I can see it.
Thanks!
Nathan
When I first got it...
http://i96.photobucket.com/albums/l162/Gilboyto/750A0038.jpg
After suspension...
http://i96.photobucket.com/albums/l162/Gilboyto/DSC05347.jpg
Coils and RUCAs....
http://i96.photobucket.com/albums/l162/Gilboyto/DSC05428.jpg