ignition cylinder wires

[westcoastpj]

hey guys,


ok.heres my problem

i tried to install a push button start because it was very difficult to start my car with the hey.you'd have to move it around.blah blah blah..ok,so i tried to install it,and had to splice the green wire from the ignition cylinder.so i cut the wire completey and soldered it back together with the push start wire.well,it all didnt work,so i jsut let it be.when i turned the car on,my radio was getting no power at all.also,the clock wasnt getting enough power because you can barely see it,and it resets everytime i turn the car off.



now the soldering job is probably the worst i have done.heres some low quality pics

http://i53.photobucket.com/albums/g50/westcoastpeejay/08-05-07_0252.jpg


http://i53.photobucket.com/albums/g50/westcoastpeejay/08-05-07_0254.jpg
http://i53.photobucket.com/albums/g50/westcoastpeejay/08-05-07_0253.jpg

could this be causing the clock to reset everytime?and for no power to get to the radio?i made sure all connections were tight.my car still starts,but it takes a couple trys.

[westcoastpj]

anyone???please help

[slamdbusa]

I would say to put it back the way it was and get a new key cut. I had problems with turning the key and a new key fixed it.

But if you want to have a push button, disconect the factory signal wire from the starter and put in another one wired to a switched (when in run) power wire.

[westcoastpj]

ok..thanks for the reply



also,there seems to be almost no poswer going to the clock.and everytime i turn the car off it resets...any help?just got a new ignition cylinder harness and it still does same thing

[slamdbusa]

It's possible that a fuse got blown.

[westcoastpj]

none of the fuses look blown?hmm.i'll check again.i only checked the audio ones.could it be another fuse?