Munkee
07-30-2007, 12:45 PM
Hi there, I have a 91 240sx fastback chassis for sale. Car is white, has complete interior, suspension, and exterior (all stock). ECU, engine, and trans have been removed from the car. Wiring harness is still there, though 2 or 3 clips are missing (maf and coil for sure). Have the title and is clean.
The bad: car was curb checked by the previous owner on the front drivers side. no visable damage, however the lower rad support was bent. We removed the old one and welded in a new rad support, but the after welding in the pass side, there is about an inch gap between the drivers side frame and the rad support. It is fixable by a frame shop, or as my friend suggested, can be tube framed, but thats more work than I was willing to do w/ this car. If anybody is willing to do the work, its a good starter for a swap project or race car.
Looking for $300, buyer will have to arrange pickup. Engine/trans/ecu available at extra cost.
munkee82(AT)gmail(DOT)com
Thnx
The bad: car was curb checked by the previous owner on the front drivers side. no visable damage, however the lower rad support was bent. We removed the old one and welded in a new rad support, but the after welding in the pass side, there is about an inch gap between the drivers side frame and the rad support. It is fixable by a frame shop, or as my friend suggested, can be tube framed, but thats more work than I was willing to do w/ this car. If anybody is willing to do the work, its a good starter for a swap project or race car.
Looking for $300, buyer will have to arrange pickup. Engine/trans/ecu available at extra cost.
munkee82(AT)gmail(DOT)com
Thnx