PDA

View Full Version : Shifting issues

minhbestunnin
07-28-2007, 01:04 PM
So I just installed my Sr20det Redtop Motor in my 91 240sx (my first time ) started right up , no problems , no check engine light or anything ... it used to be an automatic ... i conveted it nicly ... bleed the system, but the pedal never got pressure ... so i buy a new slave cylinder ... little bit of pressure but not much ... so i bought a new master cylinder ..bleed it again for like 30 minutes ... more pressure ... and now i can visually see the slave cylinder move in and out ( it wasnt before ) .... but theres still a dead zone about half way down the pedal, you dont feel pressure till half way down the pedal , so as i go to test drive it , it wont go into gear... just as i thought it would, be i guess it was just wishful thinking ... any ideas ? .... i dont wanna take off the transmission if its a simple fix , but i guess if you guys cant think of anything i guess ill have to ... any help at all would be greatly apreciated .
BattleRoyale
07-28-2007, 01:16 PM
did you adjust the clutch pedal?
minhbestunnin
07-28-2007, 01:24 PM
yea i did, almost all the way out , i think theres like 1/4 inch left
s13monkey
07-28-2007, 02:15 PM
Is your clutch hard line connected to the rubber or steel line (which ever you have) that gose to you slave cylinder. most people connect there clutch hard line directly to the rubber or steel line (which ever you have)that gose to there slave cylinder.
minhbestunnin
07-28-2007, 02:52 PM
there you go , i got it thanks everyone ... i just ran 1 line from the master cylinder straight to the slave .... got rid of all the other excess lines ... pedal is stiff as hell now , thanks
s13monkey
07-28-2007, 03:06 PM
please add possitive rep. to all that help so people would continue helping others
Drft_14
07-30-2007, 09:54 PM
anybody know where i can get that hard line that comes from the clutch master cylinder and connects to the slave cylinder?
Dousan_PG
07-30-2007, 10:05 PM
the dealer...
fliprayzin240sx
07-30-2007, 11:12 PM
anybody know where i can get that hard line that comes from the clutch master cylinder and connects to the slave cylinder?

Look around ebay, theres a steel braided line that you can use ($50 iirc) saves the hassle of using the stock hardlines...
Sileighty_85
07-31-2007, 06:36 AM
EnjukuRacing sells one for $40 Works great