arp extended wheel studs

[Mr. Samurai]

anybody using arp wheel studs? I've searched and i've found the specs

I know the arp-100-7708 set will for the rears, but I wanted to know what arp studs could be used for the front. I found this set: arp-100-7717 (specs are below) I know the thread pitches are different but I just need to know if if the studs will fit in the hub. can someone confirm?

Front:
42mm length
14.3mm X 36T spline
M12X1.25

ARP arp-100-7717 specs :
Thread Size: 12mm x 1.50 RH
Knurl Diameter: 0.565 in.
Underhead Length (in): 3.000 in.
Knurl Length (in): 0.270 in.

[On2]

You might have to have a shop turn the knurl down a tiny bit. You could just try turning it in but I'm afraid it would stress.

3" is a bit long. 76.2mm

[Sir]

I got the rears. I <3 them a lot.
For the front I tried to install the Moroso that use the old camaro thread, but it didn't go so well. Than I got Peak studs for the front.

[Slidin240Wayz]

http://www.zilvia.net/f/showthread.php?p=1120262#post1120262

[DP_Michelle G]

i'm using the ones for the evo on my ichiba hubs

[Mr. Samurai]

http://www.zilvia.net/f/showthread.php?p=1120262#post1120262

Thanks, but I'd rather use ARP studs I've stretched moroso studs before. I know how to install them I just need to know if they ARP set i listed will fit diameter wise and if they're the same number of teeth as the stock hub.

Edit: I'm an idiot I should've read the whole thread before i post a reply next time. Thanks, that pretty much answered all my questions.

[apex]

i got them front an rears on my s13 hold up nicely got them from
splparts.com they were the cheapest i found them at

but the down side u have to get new lug nuts with them
cuz they are 1.50 like honda an we use 1.25
but them also sell open end lugs to fit
http://www.splparts.com/