HKS Actuator JP to EN

[hellllo]

I've search 5 pages of "hks actuator" and couldn't find my solution. I've seen other people asking but no one answered them.

I bought a T28 HKS actuator, and i was wondering what were the conversions for length the arm of the WGA to boost (ex. inch/mm = ?? bar) I can't read japanese so I'm having a hard time with the manual.

Also would i measure it with the bracket off the WGA or with it on?

Thx in advance!

[slider2828]

If I remember, there is a webpage out there that tells about stacking washers or something. Check

http://www.zeroyon.com/

I think they had something on that.....

[hellllo]

Mainly i was asking like how much inch/mm = bar/psi, because i saw a install guide in google and it said 128mm is the stock boost but i dont it goes with all WGAs

[lok]

I dont think there are conversions for that.

Are there anything in the instructions or does it even have any instructions?

I just messed with mine till i had it set to what i wanted.

If it started to go past what i wanted i just went and changed it.

[DRIFTING_SIL_EIGHTY]

just measure your stock one and go from there. adjust until desired (allowable) boost.


If I remember, there is a webpage out there that tells about stacking washers or something. Check

http://www.zeroyon.com/

I think they had something on that.....
^^^^ thats reffering to stock actuator's

[Mlogue84]

English Instructions:

http://www.hksusa.com/faq/?ID=1545

[hellllo]

They are still closed, or not answering phones right now. I'll try a bit later thanks

But from my research, stock boost 7 psi on HKS t28 actuator = the length of the WGA arm (not pulled) with the wastegate closed?

[lok]

My s14 t28 is ~.5 bar on the stock wastegate.

Why did you buy the actuator?

Seems like you are over thinking this.

[Mlogue84]

What's your setup?

[DRIFTING_SIL_EIGHTY]

They are still closed, or not answering phones right now. I'll try a bit later thanks

But from my research, stock boost 7 psi on HKS t28 actuator = the length of the WGA arm (not pulled) with the wastegate closed?
that sounds right. when i had mine, i shortened it to were i can barely pull it to connect. and it spiked to 14??? but then dropped to 12 or 10 (i forgot). this was on stock s14 t28.

-when you called they may have been on lunch. if you call now someone should pickup. but if not leave a message. one of our tech's is off today. but they'll prolly tell you the same thing. trust me, i just asked.

[steve shadows]

I've search 5 pages of "hks actuator" and couldn't find my solution. I've seen other people asking but no one answered them.

I bought a T28 HKS actuator, and i was wondering what were the conversions for length the arm of the WGA to boost (ex. inch/mm = ?? bar) I can't read japanese so I'm having a hard time with the manual.

Also would i measure it with the bracket off the WGA or with it on?

Thx in advance!


you could use a boost gauge and just roll on carefully thats what i do

[yokotas13]

i bought one yesterday

pu tit on the car and see what it is at

then shorten it ot raise boost

mine is like as short as i can make it almost at 14.5 PSI
with a boost controller i hit 1.2 bar