PDA

View Full Version : Where does this go? S13 SR20DET BT


kylaris
07-19-2007, 09:03 PM
I was taking the intake manifold and injector rail out, and this came out of nowhere.
It's like hard plastic spacer.
Can some one tell me where these go?

http://img120.imageshack.us/img120/4564/spacerbv2.jpg

breakindrifts
07-19-2007, 09:09 PM
They are the injector seals, they sit inside the intake manifold and keep your injectors fitted properly. You should have 1 more, make sure you put those back where the injector holes are before putting in your injectors or you will have a fuel leak.

s13monkey
07-19-2007, 09:14 PM
its your injector seal they go on your manifold

kylaris
07-19-2007, 09:18 PM
no I have those, these are hard plastic, and these are lot smaller in size.
The ones used for seal are rubber.
http://img382.imageshack.us/img382/1441/sidebysidecopylz5.jpg

slider2828
07-19-2007, 09:47 PM
These are the spacers which are used for mounting either the injector fuel rail to your manifold, or the manifold to the block. I so don't remember, but they are spacers and you need them. See if there are any gaps anywhere.

projectRDM
07-20-2007, 07:40 AM
Fuck guys, way to go confusing this thread.

Hard plastic = NOT the injector o-rings to the manifold. Those are rubber.

The spacers in question sit between the fuel rail and the intake manifold, there should be two for a KA, three for an SR.

fast250sx
07-20-2007, 08:07 AM
those hard plastic things fell out when you took the bolt that is holding the rail down. they go in between the mani and the rail.

kylaris
07-20-2007, 10:23 PM
yeah, the plastic spacers went in between for intake mani and injector rail.

thanks everyone.