z32 and s14 brake master cylinder clip

[innovations]

can you use the clip for the sensor from the s14 on the z32?

[samms95s14se]

Best thing to do is use the stock 240sx container on the 300zx master cylinder it pops right in so you can use the original conector. Or you can splice in a 300zx conector to the 240's wiring and use the 300zx container.

[GSXRJJordan]

^^^ it's just a low brake fluid sensor... not your actual brake light sensor. I know my S13 sensor fit right in to my z32 MC, but not the Z31 I switched to. FYI for all those running Z31 MC/Z32 TT front/stock rears like me.

[innovations]

thanks that helped alot

[The Chad]

I agree. The S13 Is much more of a direct swap as far as factory hardware goes. As for the S14, The plugs are different, like was said before, I just spiced in my existing wires to my Z32 pigtail and plug. Or if you are feeling lazy, My friend just cut his off, just remember to check your fluid semi frequently if you decide to do that, esp after a master cyl and caliper swap. Good luck with everything!
:)