turbo rebuild question?

[turbo2nr]

http://i18.tinypic.com/66cx4l4.jpg

i am rebuilding my turbo and i am upgrading to a 360 thrust bearing with a dynamic seal and bronze journal bearing.

my question is my curret set up has just the dynamic seal and 270 degree thrust bearing.

the new setup comes with the 360 degree thrust, dynamice bearing and two other parts

a c-clip looking thing ( not the one that wholes the journas in place) and a washer with a raised side. both are pictured on the bottom.

where does these two new parts fit? im guessing some where on he dynamice seal?

fyi im calling the dynamic seal the thing that looks like a spinning top with wholes on it the 3 item on the top row form the left.

thanks

[misfitsfreak81]

who did you get the rebuild kit from? did they provide directions? i would contact the place that sold you the kit and ask them about it. also what turbo is it?

mike

[turbo2nr]

i got it form percision turbo, its a rebuild kit for t3 or t4 ( they use the same internals) im using it to rebuild my t04b.

as for instructions, their is no real instructions each turbo is different to an extent, i called up percision earlier in the week and spoke with the tech, thats why i chose this rebuild for the beffier internals. i know how everything else fits it just the two new peices that i mentioned above have me stumper on where they go, they look like they fit some where around the dynamice seal.