Ka to Sr Bell housing Swap!!! HELP!!!

[longdy]

I have been looking all over the place; in the search forms and others sites but i haven't found alot of good and solid help for swapping a KA tanny on to a SR20det. so if any body could help me out with this issue or have any idea where the write up is give me heads ups!!!

thanks...

ehhh my car with only 320hp ripped apart my tranny and im in need of a tranny too...lol :wtc:

[DemonicDonut]

step 1: unbolt KA bell housing
Step 2: bolt on SR bell housing
step 3: re-install tranny.

Its pretty simple.

[uthemofo]

ok dude i did it my self but didnt take pictures or do a write up or anything, but here's the basics. Its fairly simple actually really simple.
First thing you do is remove the cover in the inside of the bell housing, should be a couple number 12s. Once you do that there is 2 "C" clamps holding the tranny together, take them out, dont loose them. The middle of the tranny has a steel plate with number 12s all the way around it. Take all of them out. The tranny is pretty tough to seperate from that bell housing due to sealant. Try with a screw driver and a dead blow hammer.

hope this helps
-matt

[projectRDM]

step 1: unbolt KA bell housing
Step 2: bolt on SR bell housing
step 3: re-install tranny.

Its pretty simple.

What he said. If you got the transmission out of the car you should have no problem swapping the bellhousing, it's literally self explanatory.

[1QUICK4]

finally found what i was looking for

[IES13]

Can this be do with swapping a auto KA into a SR20DET which was previously a 5-speed?

[Katsumbhong]

For some reason I thought the KA and SR Bellhousings were the same....

[opponheimer]

For some reason I thought the KA and SR Bellhousings were the same....


They are the same, but people would rather have the sr housing because its aluminmum as opposed to the cast iron ka housing, and its jdm :D





jk btw



Make sure you have some snap ring pliers when taking the bell housing off

[longdy]

wow... lol this tread is still alive...haha i thought it was dead awhile ago... but yea

UPDATE* got the bellhousing swapped perfectly but only to find out that it wasnt the Tranny!!!....lol

[steve shadows]

wow... lol this tread is still alive...haha i thought it was dead awhile ago... but yea

UPDATE* got the bellhousing swapped perfectly but only to find out that it wasnt the Tranny!!!....lol

I TOLD YOU nanaaana na naaaaaaaa


haha

:rl:

see ya round longdy

[Katsumbhong]

They are the same, but people would rather have the sr housing because its aluminmum as opposed to the cast iron ka housing, and its jdm :D





jk btw



Make sure you have some snap ring pliers when taking the bell housing off

The j/k part was for?...