Sparco Pro 2000 and Bride Seat Rails

[Behind Horizon]

Hello guys,

i'm looking for the lowest possible seat position at the moment. I know the Bride Type FG seat rails will work with the Pro 2000 but as the Pro 2000 do not only have position mounts on the side but also on the bottom i asked myself if i can / should use Bride MO Super-Low Seat rail if it will fit.

If the Mo Super Low dont fit, i think you can make it fit by drilling new holes on the plates, the width of the mounting points on the Sparcos is 345mm.

So do you guys have experience which rails will give me the lowest possible seat position ?

Side Mount or Bottom Mount with Bride Rails, thats the question.

I'm looking forward for replys.

Greets.

BH.

[swayray]

i've have a sparco rev w/ bridge fg rails... i set the rear to the lowest... the front part on the second lowest (middle) and it sits pretty low....

http://i108.photobucket.com/albums/n3/swayray/wawa/DSCN1138.jpg

http://i108.photobucket.com/albums/n3/swayray/2.jpg

[KFLS14]

Get side mount rails plain and simple offers adjustablity. If your 5ft "8+ and ever plan to run a helmet you will touch roof slightly(especially w/ sunroof)

[Dousan_PG]

Get side mount rails plain and simple offers adjustablity. If your 5ft "8+ and ever plan to run a helmet you will touch roof slightly(especially w/ sunroof)


you wont touch roof unless your seat suckssss

look at Ray's seat

im 5"11ish and i never touch the ceiling, even when i had interior. Maxis + FG.


always side mount
unless its a reclineable
and my brix's never were that high.

quality seats = quality seating position
sparco (some models), Recaro (nearly all models), Bride (nearly all models) are great.

[swayray]

yeah... i'm 5' 8" w/ full interior and sunroof... my head never touch the ceiling w/ my helmet on....

i would not recommend the sparco rev though... the cushion always freekin moves... it sucks... i just take it off which drops me down to another inch or so....

[Slidin240Wayz]

I am 5 feet 11 inches tall.

I had a Bride Brix II with a Juran bottom mount rail. I looked straight into the top bar of my roll cage, which provided 10% visibility.

You are Germany. I would suggest the OMP RS seat. I purchased mine from www.tankslapperautosport.com for $450 shipped. My seat was shipped from Italy. Since you are in Germany, you might save some money since they ship it in the same continent. I can send you the e-mail of the contact if you would like to purchase the seat from them.

It is:
- FIA approved
- The Bride FG rail (ASpec - Logan) sits low. I could not even set it to the lowest position because the seat was hitting the transmission hump. I have the rear section set to the middle and the front set to the lowest position.
- In Europe

Carlos