quick help about offset ... 18x10 J+0 and 18x12 +13

[BILLYhoang]

hey wassup fellas , i'm really close to about purchasing a set of wheels for my 1995 s14 . i saw a set of wheels that I like and I've tried using the offset calculator and using the millimeter conversion tables and did searches to see if anyone else is running a similar offset but didnt get a solid answer ....

can you guys help me out and tell me how would these wheels fit on my S14 ?

Work VS-XX
18x10 J+0 and 18x12 +13

if it matters , i'm running stock brakes and Cusco ZERO-2R coilovers and have Cusco RUCAS and other Cusco components on the car .

thanks

[whiting]

Not on completely factory body, i would expect to pull the rear fenders HARD, I have seen a 18x10.5 +22 on the rear of a S14, and the fenders were pulled a bit.

If you have factory SE wheels, you are looking at 50mm further out tooward the fender, you should be good on inner clearance. But 50mm is a huge ammount of extra wheel sticking out, damn near 2 whole inches.

I love VS-XX's, if you REALLY want to run them pull the fenders a lot and run like 4 degrees negitive camber!

[BILLYhoang]

so the front and rear would be fine if i run 30mm front fenders and 50mm rear over fenders ?

[nrg]

yes those overfends will be fine. just add alittle more camber and those wheels will fit.

[NemeGuero]

get them and post pics.

[EDacIouSX]

i'm putting 18x9 +0 on the front. nissan4u2nv i beleive runs 17?18?x9-6 with -3.5? camber in the front with a 225 tire. in the rear i am going to run 18x10 +10 245/40 with a pull. Generally those are pretty agressive offsets for stock s14 body. check out this thread for ideas: http://www.zilvia.net/f/showthread.php?t=129865